AirMux-200 is a carrier-class, high capacity, affordable multiplexer,
connecting E1/T1 and Ethernet networks point-to-point over
a wireless link. Compliant with FCC, CAN/CSA and ETSI regulations
for licence-exempt transmission, the AirMux-200 operates over
5.725–5.850 and 5.25–5.35 (FCC,CAN/CSA) GHz, 5.470–5.725
(ETSI) GHz, 2.4–2.4835 (ETSI and FCC) GHz bands and
4.940-4.990 (FCC) bands. Wireless transmission enables enterprises
to save the cost of leased lines while eliminating the service
provider’s need for deploying fiber, thereby enabling
rapid deployment of E1/T1 and Ethernet links at a fraction
of the cost.
AirMux-200
consists of an indoor and outdoor unit connected by a Cat-5e
outdoor Ethernet cable, allowing a maximum distance of 100
meters (328 feet) between the two units. The outdoor unit
can be ordered with a various integrated antennas or with
a connector for an external antennas.
AirMux-200
integrates up to four unframed E1 or T1 ports and an Ethernet
port for a total air interface throughput of 48 Mbps. This
is equivalent to a net payload throughput of up to 18 Mbps
full duplex. The maximum range of the AirMux-200 is 80 km
(50 miles). Throughput and distance are a function of the
distance and regulation.
An integrated
10/100BaseT Ethernet bridge transparently forwards VLAN frames
and learns up to 2,000 MAC addresses. The accurate E1/T1 clock
recovery, low round trip delay and high link availability
position the
AirMux-200 as a carrier-class wireless transmission system.
An AirMux-200
link can be managed by a Windows-based application supplied
with the device. RADview SNMP fault management can be ordered
in cases where many links are deployed and managed from a
central platform. All parameter configurations are link-based,
simplifying maintenance and installation.
AirMux-200
is a perfect solution for connecting remote enterprise locations,
cellular backhaul, broadband Last Mile services and hotspot
backhauling.
Connecting Base Station and Base Station control sites
|
